Operation Manual

Section 10 TROUBLESHOOTING
2A080030A
KM-6230 (KME)
/ 131
Trouble Check point Procedure Page
The finished copies are too
dark.
Is the copier in the auto exposure mode?
To adjust the overall exposure level, perform
the “Auto exposure adjustment” procedure.
8-15
The finished copies are dirty.
Is the copier in the manual exposure mode?
Use the copy exposure adjustment keys to
adjust the exposure as appropriate.
4-1
The finished copy image is
askew.
Is the platen, the slit glass or the original
protector under the DF dirty?
To adjust the overall exposure level, perform
the “Manual exposure adjustment”
procedure.
8-16
Clean the platen, the slit glass and the
original protector under the DF.
10-20
Paper is continually misfed.
Were the originals set correctly?
When setting an original on the platen, align
it properly with the appropriate original size
indicator lines.
3-5
When setting originals in the DF, align them
securely with the original insertion guides.
3-4
Set the paper correctly.
3-1
Replace it with new paper.
3-1
Is the paper set correctly in the drawers or
decks?
Is the paper curled, folded or wrinkled?
Carry out the appropriate procedure to
remove the paper.
10-4
Is there misfed paper or loose scraps of
paper remaining inside the copier?
10-19