User's Manual

Table of Contents/Important Points
GB 25
Common precautions
External connection terminal cover,
card slot cover, and earphone
microphone terminal cover
Make sure that the external
connection terminal cover, card slot
cover, and earphone microphone
terminal cover are firmly closed. Just
a small particle (a hair, a grain of
sand, etc.) on the seals can cause a
water leak.
Do not open/close the external
connection terminal cover, card slot
cover, or earphone microphone
terminal cover with gloved hands.
Just a small particle (a hair, a grain of
sand, etc.) on the seals can cause a
water leak. Wipe off any minuscule
droplets of water or dirt with a clean,
dry cloth before closing the covers.
If the external connection terminal
cover, card slot cover, or earphone
microphone terminal cover is
deteriorated or damaged, the
waterproof property becomes
ineffective.
If any liquid other than plain water
gets on the product
If any liquid other than plain water
(e.g. seawater, detergent, alcohol)
gets on the product, immediately
rinse it with plain water.
You can wash the product under a
mild flow (up to 6 litres per minute) of
tap water at room temperature (5°C
to 35°C) at a distance of about 10 cm
from the tap or showerhead.
If the product gets dirty, do not use a
brush as you hand-wash it, holding
down the external connection
terminal cover, card slot cover, and
earphone microphone terminal cover
so that they do not open.
After the product gets wet
After the product gets wet, drain the
water, and wipe the main unit with a
clean, dry cloth. Do not blow hot air
(e.g. hairdryer) on the product.
In cold climates, water on the product
might freeze. Using a frozen product
might cause a fault. Do not leave the
product without first wiping off the
water. (No special measures against
condensation have been
implemented on this product.)