User manual

RS-232C Cable Connection
C-13
In DOS, enter the following commands:
C:\>MODE COM1:96,N,8,1,P
C:\>MODE LPT1:=COM1
To test the interface, enter the following:
CTRL P
C:\>DIR
CTRL P
The software settings made using the above procedures are temporary. On
most computers, permanent settings must be made with DIP switches.
If you want to use a different baud rate or change any of the other RS-232C
parameters, you can use the printer's FRPO (firmware reprogram)
command. Refer to the
Programming Manual
for details.