Operation Manual

6-20
Using Various Functions > Functions
Mixed Size Stapling
Even with mixed paper sizes, if the sizes have the same width or same length as shown in the combinations below, the
output can be stapled. Up to 30 sheets can be stapled.
• A3 and A4
• B4 and B5
• Ledger and Letter
• Ledger and Letter-R
• 8K and 16K
Punch
Punches holes in sets of finished documents.
NOTE
When performing Mixed Size Stapling, refer to Mixed Size Originals on page 6-14.
NOTE
• The optional document finisher (1,000-sheet finisher or 4,000-sheet finisher) and punching unit are required.
• For details on paper sizes that can be punched, refer to Hole Punch Unit (Option) on page 11-31
.
• The inch model provides two-hole and three-hole punching. The metric model provides two-hole and four-hole
punching.
Item Value Description
Punch 2 holes Left Select the position of punch holes. For details on original
orientation and position of punch holes, refer to Original
Orientation and Punch Hole Position on page 6-21.
2 holes Top
2 holes Right
3 holes Left
3 holes Top
3 holes Right
4 holes Left
4 holes Top
4 holes Right
Original
Orientation
Top Edge on Top, Top Edge on Left Select the orientation of the original document top edge to
scan correct direction. Press [Original Orientation] to choose
orientation of the originals, either [Top Edge on Top] or [Top
Edge on Left]. Then press [OK].
A3A4
B4B5
LedgerLetter
B5
LedgerLetter
A3A4
B4
LegalLetter-R
LegalLetter-R