Operation Manual

8-50
Setup and Registration (System Menu) > System Menu
Interface Block Setting
This allows you to protect this machine by blocking the interface with external devices such as USB hosts or optional
interfaces.
Data Security
Configure settings for data stored in the machine's hard disk and memory.
System/Network
Item Description
USB Host This locks and protects the USB port (A1) or USB port (A2) (USB host).
Value: Unblock, Block
USB Device This locks and protects the USB interface connector (B1) (USB Device).*
Value: Unblock, Block
USB Storage This locks and protects the USB memory slot (A1).
Value: Unblock, Block
NOTE
This function is available when USB Host is set to [Unblock].
Optional Interface 1 This locks and protects the optional interface slots (OPT1 or OPT2).
Value: Unblock, Block
Optional Interface 2
IMPORTANT
After changing the setting, restart the system or turn the machine OFF and then ON.
System/Network
Item Description
Hard Disk Initialization Initializes the system and the erasure method for data stored on the machine's hard disk. For
details, refer to the
Data Security Kit (E) Operation Guide .
NOTE
This function is displayed when the optional Data Security Kit is activated.
Data Sanitization Completely erases address information and image data saved in the machine.
NOTE
Up to 8 hours is required to complete this processing, depending on the amount of data stored.
Once in progress, the processing cannot canceled.
Before executing this function, disconnect modular, network, and other cables.
Do not turn off the main power switch while sanitizing the data. If the main power is turned off
during data erasing, erasing will be executed automatically when the power is restored,
however, complete erasure cannot be guaranteed.
Software Verification Verify the installed software.
Press [Start] to start verification.
If an error occurs during software verification, contact your dealer or service representative.