Instruction Manual

4.3.17 AUTO HOLD Function

The instrument can automatically retain the measured value

when the test leads are handled as described below.

1) Press the HOLD key to select Auto hold function.

 (Thedisplayshowsthe“A•H”symbol.)

2) Connect the test leads to the circuit under test.

3)Whenthereadingstabilized,thebuzzersounds.

4) Remove the test leads from the circuit under test.

5) The display shows the measured value that is retained.

 Youcanrepeatsteps2)to4)asmanytimesasyoulikeaslongasthedisplayshowsthe“A•

H ” symbol.

Note

• InDC/ACvoltagemeasurement,theAutoholdfunctionisonlyavailableforrangesgreater

than the 5V range.

• ThisfunctionisnotavailableforTemperature,CapacitorandFrequencymeasurement.

• TheAutoholdfunctioncannotbeappliedtounstablesignals.