User guide

① Set the function selector switch to the " ∼ A" position. “AC"

should be shown on the upper left corner of the display.

② Press the trigger to open the transformer jaws and clamp them

onto a single conductor and take the reading on the display. The

most accurate reading will be obtained by keeping the conductor

at the center of the transformer jaws.

NOTE

● During current measurement, keep the transformer jaws fully

closed. Otherwise, accurate measurements cannot be taken.

Maximum conductor size is 55㎜ in diameter.

● Zero adjustment is not necessary in AC current measurement.

● When the current under test measures 3% of the range or less,

or the frequency of the current is low, "LoHz" is indicated on the

display.

６－３ DC Voltage Measurement

 DANGER

● Never use the instrument on a circuit above 1000VDC. This may

cause electrical shock hazard and damage to the instrument or

the circuit under test.

● Do not make measurement with the battery compartment cover

removed.

● Keep your fingers and hands behind the barrier during

measurement.

Red test lead

Black

test lead