User guide

̶
28
̶
８．Battery Replacement
 WARNING
● To avoid electric shock hazard, make sure to set the function
selector switch to "OFF" and remove the test leads from the
instrument before trying to replace battery.
 CAUTION
●Do not mix new and old battery.
● Make sure to install battery in correct polarity as indicated in the
battery compartment.
If the battery voltage becomes too low for the instrument to operate
normally, "
" is shown on the display. Then, replace the battery.
Note that when the battery is completely exhausted, the display
blanks without " " shown.
①Set the function selector switch to the "OFF" position.
② Unscrew and remove the battery compartment on the bottom of
the instrument.
③ Replace the battery observing correct polarity. Use a new R6P or
equivalent battery.
④Re-place and screw the battery compartment cover.
Screw
Batteries