Owner's manual

̶ 14 ̶
8-5 Memory function
This function is to save and display the measurement results.
󱛠 Saving the measurement results
( 1 ) Select any data number (from 1 to 100 ) by using the Cursor button
or at ACA or Earth resistance function, and save the measurement
results.
◇ When the Cursor button is being pressed down, the number switches
quickly.
( 2 ) To save the measurement result being displayed on the LCD, press the
Save button . Then the result is saved to the selected data number.
(" MEM " is displayed for about 1 second.)
◇ After saving the data, data number automatically switches to the next
available data number (present data number + 1 ) and the next measured
value can be saved to it.
(The data number returns to 1 after the measurement result is saved to
the data number 100 .)
◇ When the new measurement result is saved to the data number on
which the previous measurement result is saved, previous data will be
overwritten.
◇ When saving a data while the data hold function is activated, the
readings which is being held on the LCD will be saved.
󱛠 Recalling the measurement results in memory
To activate the memory function, press the Memory mode button .
Then " MEM " is displayed on the LCD.
Pressing the Cursor button or changes the data number displayed
on the LCD, and the measurement result in memory is displayed accordingly.
◇ To disable the memory mode, press the Memory mode button again or
press the Function button . (Then " MEM " symbol disappears.)
◇ Bars " " are displayed for the Data number that does not contain
any test result.
󱛠 Clearing the measurement results in memory
To clear the measurement result, press the Save button with the Memory
mode button
pressed down. The message " " is displayed on the
LCD for about 2 seconds and the measurement result on the selected data
number is cleared.
(Then the indication on the LCD becomes " ".)
◇ Follow the procedure below to delete the all measurement results.
( 1 ) Press the Power button , while the instrument is off, while the
Memory mode button and the Save button are being pressed down.
Then release the Power button only.
( 2 ) Instrument is turned on; " MEM ", " " and " " are displayed
on the LCD for about 2 sec..
Now all the stored data are deleted.