Instruction Manual Instruction Manual

̶
45
̶
WARNING
󱛠
In order to avoid electrical shock, remove sensors from the instrument
when replacing batteries.
CAUTION
󱛠
Do not mix new and old batteries.
󱛠
Install batteries in the orientation as shown inside the battery
compartment, observing correct polarity.
When only the leftmost segment of the Battery mark
is flashing
on the LCD, it means battery voltage is low. Replace the batteries with
new ones. There is no influence on the measurement accuracy even
if this warning mark is flashing. Nothing even the Battery mark is
displayed on the LCD if the batteries are completely exhausted.
Replace the batteries with new ones.
(1) Loosen two Battery-cover -fixing
screws on the backside of the
ins trum ent and remo ve the
cover.
(2) Replace the batteries with new
ones.
(Battery : Alkaline, LR6, 1.5V)
(3) Install the Battery cover, and
tighten up the screws.
11. Battery replacement