Quick Manual Instruction Manual

− 22 −
KEW6305
KEW6305
How to start/ stop measurement
Start measure-
ment
LED
LED blinks
Stand-by
mode
8-2. How to start/ stop measurement
● To start/ stop measurement manually ● To start/ stop measurement at the preset date&time
Hold down the
START
/STOP
Key for
over 2 sec.
DEMAND
Range
Configure the settings for “Setting
14/15”, and then press the
START
/STOP
Key.
File no. screen is displayed for about 2 sec.
- Manual operation : Pressing the
START
/STOP
Key starts measurement anytime.
- Automatic operation : KEW6305 enters into stand-by mode and wait until the
preset start time comes.
The Status indicator LED blinks when the instrument is in stand-by mode and it
stays on when measurement starts.
* Display is updated every 1 sec.
* Data will be saved at the interval selected at “Setting 13”.
* Buzzer sounds when a predicted value exceeds a target value set
at “Setting 15” in the pre-set period set at “Setting 17”.
* While performing measurement, select the W Range to view
instantaneous values, Wh Range to view integration values and
SET UP Range to check the details of settings.
Manual operation
Hold down the
START
/STOP
Key for over
2 sec.
Automatic operation
Measurement stops automatically
when the preset date& time comes.
The status indicator LED goes off when measurement stops (or file is closed).
* When the destination to save data has been set to the internal memory, “
” symbol is displayed
on the screen instead of “ ” symbol.
Integration values remain displayed on the LCD when measurement ends.
Press the “
ESC
” Key at least 2 sec to select “dEL” and clear the display if the displayed values will not
be used in further measurements.
LED lights up
Measuring
Stop measurement