User Manual

KEW6310 3.2.1 Battery
KEW6310 3.6
Rechargeable batteries
This instrument can charge rechargeable batteries via AC power supply.
1 Loosen two Battery Cover-fixing screws and remove the Cover.
2 Take out all the batteries.
3 Loosen the screws and remove the Selector Switch Cover.
Attention should be paid so as not to lose the screws.
4 Slide to left and set the Selector Switch to “RE-CHARGEABLE” position.
5 Install the Selector Switch Cover with the marking of rechargeable battery faced up, and tighten the
screws.
6 Insert batteries (HR-15/51 : size AA Ni-MH recha rgeab le ba tteri es) in co rrec t pola rity.
7 Install the Battery Cover and tighten two screws.
8 Connect the AC Power Cord and power on the instrument.
~ Battery charge ~
Message w indow s on the nex t p ag e appe a r when st a rti ng the in strume nt under fol lowing conditions and with
battery level of 40% or less.
* Inst all rechar geab le ba tterie s (N i- MH)
* Slide and set the Selector Switch to “RE-CHARGEABLE” position.
* Connect the AC Power cord and power on the instrument.
Refer to “4.2.4 Other Settings” and see the procedure to start battery charge any time.
9 Follow the message displayed on the LCD and press the Cursor and ENTER Key s to st art
charging batteries. Selecting “No” returns to the normal screen.
Battery charge doe sn’ t initia te only by installing recha rgeabl e batte rie s and conn ecting an AC power cord.
Above operation is required to start a battery charge.