User Manual

3.4.2 Error message KEW6310
3.13 KEW6310
3.4.2 Error message
Following screen may appear after a self-check routine.
When a failure is detected;
This instrume n t auto ma tica lly checks the inte rnal circui t im media tely a fter i t is pow ered on .
If a suspect failure in the internal circuit is detected, the error screen below will be displayed for about 5 sec.
In this case, refrain from using the instrument and refer to Sec tion15 : Troubleshooting in th is manual .
CAUTION
Notwithstan ding the er ror scre en, the me asu remen t screen w ill appea r and the instru men t w ill take
measurements anyway. However, accurate readings may not be obtained.
When connected sensors are changed;
Clamp sensors co nnected are di splay ed for 5 sec as fol low s. When no sen sor is conne cted , previo us
settings are kept.