Owner manual

MODEL 8246
Function Setting for Printer
INSTRUCTION
MANUAL
<2> DIP SW2
Switch No. Function ON OFF
Reduced print
Normal print
(40 columns)
1 Printing Columns
(80 columns)
DIP SW (DIP switch) 1 to 3 for the MODEL8246 Printer are set to the
settings in the following tables as the factory setting (factory default setting).
Default setting is Japanese. (No.1 to 5 of DIP SW2)
When having changed the settings or the printer does not operate normally, check
that
the settings are set to the default. If the settings are different from them, set the
settings again to the default.
For detailed information about the handling such the function setting, refer to
the instruction manual of the DPU-414 printer made by Seiko Instruments Inc.
■Applicable instruments
DIGITAL Multimeter MODEL KEW1061,KEW1062
■Accessories of Printer
8248 AC adapter for printer
8247
Thermal paper for printer
8243
Printer Communication set
■ Function Setting for Printer
<1> DIP SW1
Switch No. Function ON OFF
1 Input Parallel Serial
2 Printing Speed High-speed Low-speed
3 Auto Loading ON OFF
4 Auto LF ON OFF
5 Setting Command Enable disable
6～8 Printing Density See below
Switch No. Printing Density
(%)
6 7 8
100 OFF ON ON
2 User Font Back-up ON OFF
Special
character
Normal
3 Character Select
character
4 Zero 0 0
5～8 International Character Set See below
Switch No.
International
Character Set
5 6 7 8
Japanese ON ON ON ON
<3> DIP SW3
Switch No. Function ON OFF
1 Data Length 8 bits 7 bits
2 Parity Setting No Yes
3 Parity Condition Odd Even
4 Busy Control H/W BUSY XON/XOFF
5～8 Baud Rate Select See below
Switch No.
Baud Rate (bps)
5 6 7 8
9600 OFF ON ON ON
92-2003
8-08