User's Manual

iSurf 1000 User Operation Manual
- 5 -
5. Rear Panel Description
Interface Function Description
12V DC Power connector DC Power Supply with harmonic suppression: 12V 1.5A.
Reset Device Restart and Factory
Default Reset
Press and immediate release: reboot the device.
Press and hold (10 seconds): Reset the device to factory
default settings. User configuration data will be deleted.
WPS Wi-Fi Protected Service Access Press the WPS button to begin automatic user access
process. The LED will be blinking during the negotiation
and login process.
WAN WAN ETH Port (RJ45) Connect to ADSL modem or IP network for Internet
access
LAN 1-3 LAN ETH Port (RJ4) Connect to PC, LAN Switch or Ethernet networking
equipment.
FXS Ports 1-2 Analog Phone jack (RJ11) Two independent voice line to connect to analog phone
or fax machines.
USB USB 2.0 OTG Networking
Interface
Used for connection 3G or 4G USB devices. Support plug
and play for instant networking.
WiFi WiFi Antenna (2x2 MIMO) Support 2x2 MIMO 802.11b/g/n, Up to 300Mbps
maximum speed.
6. Installing Device
Before installing the device, please make sure you have applied and activated the internet service from your service
provider. To install the device, the user should follow the steps below. For safety, please keep your hand dry when
operating the device.
【1】 Open the packing box and take out the device. Place the device on table and rotate the WiFi antenna
upwards.