Install Manual Part 3
Table Of Contents
- CHAPTER 4- MAINTENANCE
- APPENDIX A - SIGNAL & CABLE CHARACTERISTICS
- APPENDIX B - CHECKOUT USING TCAS-201 RAMP TEST SET
- APPENDIX C - CHECKOUT USING T-49C FLIGHTLINE TESTER
- APPENDIX D - USING THE TERMINAL DEVICE
- APPENDIX E - CHECKOUT USING ALTERNATE DISPLAY
SKY497
Installation Manual
4-2
Rev. C
4.4 SERVICE MENU
The Service Menu is intended as an aid in installing, testing and troubleshooting the SKY497. Service
Menu items are to be used only for testing and troubleshooting an installation. The Service Menu is not
intended to be used by the pilot during normal system operation. When interfaced to an alternate display
the service menu functions must be performed by using an RS-232 terminal device, see appendix D for
operating instructions.
The Service Menu is accessed by holding soft-keys (1) and (2) (the left two buttons) depressed as the
system is turned on. Hold the buttons until the Service Menu is displayed. The Service Menu is shown in
figure 4-1.
Figure 4-1. Service Menu
The buttons perform the following operations:
• EXIT - causes the system to exit the Service Menu and run the power on self-test.
• SELECT - selects the highlighted item.
• PREV - steps to the previous item.
• NEXT - steps to the next item.
The Service Menu provides the following choices:
• Calibration
• System Log
• System Data
• Ground Test (Available only if squat switch input indicates aircraft is on the ground.)
The individual menu items are explained in the following paragraphs.
NOTE
Service Menu screens are shown for documentation purposes only. Each system
may be configured differently and live data will correspond to the sensors
installed in a particular aircraft..