Install Manual Part 3

SKY497
Installation Manual
D-4
Rev. C
Commands Descriptions
Dump (help)
Displays the error messages stored in the error log. If no errors are stored in
the system log, the message NO FAULTS DETECTED is displayed.
Dump help: Displays command specific help message.
Dump: Displays system error log.
stp>dump
SKY497 SYSTEM LOG
System Time - 00704:14
Err# Time
Description
019 - 00693:41 - RF Transmitter
018 - 00668:47 - RF Angle
020 - 00668:03 - Barometric Altitude Input
024 - 00647:52 - Processor Reset
153 - 00647:38 - HDG
Ground (help | test | off)
SKY497 enters the ground test mode.
Ground help: Displays the command specific help message.
Ground (or Ground 0ff): Exits ground test mode (if active).
Ground Test: Enters ground test mode.
stp> ground help
Parameter:
TEST to enter ground test mode or OFF (or nothing) to exit mode
stp>ground
System no longer in Ground Test Mode
Returning to aircraft sensors and switch inputs
stp> ground test
System in Ground Test Mode
Simulating Barometric Altitude: 50,000 ft.
Simulating RADAR Altimeter: 2,500 ft.
Simulating Heading: 0 deg
Gear and Squat switch override in effect
Head (help)
Displays the current heading source, degrees, and heading flag status (valid
or invalid). Heading source is latched during turn on and will not change
until power is cycled, all other data is live.
Head help: Displays the command specific help message.
Head: Displays heading data.
stp>head
Heading Source: Synchro XYZ
Heading: 0 degrees
Flag line: Valid