Install Manual Part 3
Table Of Contents
- CHAPTER 4- MAINTENANCE
- APPENDIX A - SIGNAL & CABLE CHARACTERISTICS
- APPENDIX B - CHECKOUT USING TCAS-201 RAMP TEST SET
- APPENDIX C - CHECKOUT USING T-49C FLIGHTLINE TESTER
- APPENDIX D - USING THE TERMINAL DEVICE
- APPENDIX E - CHECKOUT USING ALTERNATE DISPLAY
SKY497
Installation Manual
4-8
Rev. C
NOTE
The RS422 Interface is used for factory testing and evaluation.
Figure 4-9. Configuration - Page 2
Page 2 of 4 (see figure 4-9) displays:
• Barometric Encoded Altitude (in Gray Code and Feet)
• Connector P1 Pin Assignments for Data Inputs
Figure 4-10. Configuration - Page 3
WARNING
Verify displayed antenna position matches antenna location on the aircraft
(top or bottom). Failure to do so could give incorrect traffic bearing.