Manual

ManualsBrandsL.B. White ManualsRadiators170 Classic

Table Of Contents

All Models are

available in

either Propane

Vapor Withdrawal

or Natural Gas

Configurations.

Congratulations!

You have purchased the finest heater available.

Your new L.B. White heater incorporates the benefits from the most experienced

manufacturer of heating products using state-of-the-art technology.

We, at L.B. White, thank you for your confidence in our products and

welcome any suggestions or comments you may have...call us, toll-free,

at 1-800-345-7200.

Owner's Manual and Instructions

Construction Heaters

Certification by:

ATTENTION ALL USERS

This heater* has been tested and evaluated by C.S.A. International in accordance

with Standard ANSI Z83.7

CSA 2.14 and is listed and approved as a direct gas-fired

circulating construction heater with intended use for primarily the temporary heating

of buildings under construction, alteration, or repair. As an alternative use, this

heater has also been tested and evaluated by the L.B. White Co., Inc. for the heating

of agricultural animal confinement buildings and has been used in such

applications for many years. If you are considering using this product for any

applications other than those previously stated, then please contact your fuel gas

supplier or the L.B. White Co., Inc.

MODELS OUTPUT (Btuh) FUEL

408, 410* 170,000

* The --3 and --4 versions of these heaters are not listed

and approved heaters.

150-23336-A

Summary of content (16 pages)

PAGE 1
Owner's Manual and Instructions Construction Heaters MODELS 408, 410* OUTPUT (Btuh) 170,000 FUEL All Models are available in either Propane Vapor Withdrawal or Natural Gas Configurations. Certification by: * The --3 and --4 versions of these heaters are not listed and approved heaters. Congratulations! You have purchased the finest heater available. Your new L.B. White heater incorporates the benefits from the most experienced manufacturer of heating products using state-of-the-art technology.
PAGE 2
GENERAL HAZARD WARNING ■ Failure to comply with the precautions and instructions provided with this heater, can result in: — Death — Serious bodily injury or burns — Property damage or loss from fire or explosion — Asphyxiation due to lack of adequate air supply or carbon monoxide poisoning — Electrical shock ■ Read this Owner’s Manual before installing or using this product. ■ Only properly-trained service people should repair or install this heater. ■ Save this Owner’s Manual for future use and reference.
PAGE 3
Table of Contents SECTION PAGE General Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 Heater Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 Safety Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PAGE 4
Heater Specifications Model SPECIFICATIONS 408 410 Propane Gas Natural Gas Maximum Input (BTUH) 170,000 Ventilation Air Required to Support Combustion 700 CFM Inlet Gas Supply Pressure Acceptable at the Inlet of the Heater for Purpose of Input Adjustment MIN. Burner Manifold Pressure Fuel Consumption Per Hour 13.5 in. W.C. MAX. MAX. 11 in. W.C. 7 in. W.C. 10 in. W.C. 4 in. W.C. 7.87 lbs. 170 cu. ft. Ball Bearing 1/5 H.P.
PAGE 5
Safety Precautions WARNING ■ ■ ■ ■ ■ Asphyxiation Hazard Company to determine combustion air ventilation Do not use this heater for heating human living quarters. requirements of the heater. Do not use in unventilated areas. ■ Lack of proper ventilation air will lead to improper combustion. The flow of combustion and ventilation air must not be obstructed. ■ Improper combustion can lead to carbon monoxide poisoning in humans leading to serious injury or death.
PAGE 6
1. Do not attempt to install, repair, or service this heater or the gas supply line unless you have continuing expert training and knowledge of gas heaters. Qualifications for service and installation of this equipment are as follows: a. To be a qualified gas heater service person, you must have sufficient training and experience to handle all aspects of gas-fired heater installation, service and repair.
PAGE 7
accordance with Chapter 5 of the Standard for the Storage and Handling of Liquefied Petroleum Gases, ANSI/NFPA 58. 20. Propane gas supply cylinders have left-handed threads. Always use a wrench to make the connection to remove the P.O.L. fitting. Do not use pliers. Installation Instructions GENERAL WARNING Fire or explosion hazard. Can cause property damage, severe injury or death. 1. Disconnect power supply before wiring to prevent electrical shock or equipment damage. 2.
PAGE 8
proper application of pipe compound before further tightening. -- Tighten the gas connection as necessary to stop the leak. -- If necessary, replace the parts or components involved if the leak cannot be stopped. -- Ensure all gas leaks have been identified and repaired before proceeding. 12. A qualified service agency must check for proper operating gas pressure upon installation of the heater. 13. Light according to instructions on heater or within owner's manual. 16.
PAGE 9
HANGING INSTRUCTIONS 1. Assemble according to the illustration and tighten all eyebolts securely. (See Fig. 2): FIG. 3 NOTE: REGULATORS SHOULD ALWAYS BE MOUNTED OUTDOORS. IF CIRCUMSTANCES FORCE INSTALLING THE REGULATOR INDOORS, THE REGULATOR'S VENT MUST BE VENTED OUTDOORS USING VENT LINE NO SMALLER THAN VENT OPENING.
PAGE 10
THERMOSTAT INSTALLATION WARNING Electrical Shock Hazard 2. To Connect the Direct Wired Thermostat Kit to the Heater: a. The installation and wiring of a thermostat must be done by an electrician or someone properly qualified. ■ Disconnect the electrical supply before connecting the thermostat to the heater. ■ Failure to follow this warning can result in electrical shock, leading to personal injury or death. b.
PAGE 11
Cleaning Instructions WARNING Fire, Burn, and Explosion Hazard ■ This heater contains electrical and mechanical components in the gas management, safety and airflow systems. ■ Such components may become inoperative or fail due to dust, dirt, wear, aging, or the corrosive atmosphere of an animal confinement building. ■ Periodic cleaning and inspection as well as proper maintenance are essential to avoid serious injury or property damage. 1.
PAGE 12
Electrical Connection and Ladder Diagram CAUTION Always refer to the heater’s electrical connection diagram when servicing to avoid wiring errors and heater malfunction. Check for proper operation after servicing.
PAGE 13
Heater Component Function Air Proving Switch Safety device used to insure that the proper air flow is being achieved before the gas valve is opened. (115,000 and 170,000 Btuh Heaters) Burner Cast iron component used to channel gas and provide an area at which the fuel may ignite. Burner Orifice Brass metering device used to feed gas to burner at a specific rate. Fan Housing Chamber used for compressing air for efficient air movement.
PAGE 14
Parts Identification PARTS SCHEMATIC 29 28 27 26 30 33 25 31 19 24 18 32 20 23 17 34 22 35 15 36 8 21 1 16 14 7 4A 13 12 11 4 39 9 6 10 5 N 38 2 37 14 3 Y PL UP S .G. AS . G LY P .
PAGE 15
PARTS LIST Item 1 2 3 4 4a 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 Description Regulator, Single Stage (Propane Gas) Regulator, Second Stage (Propane Gas) Hose, 1/2 in. x 10 ft. Adapter, 1/2 NPT x 1/2 NPS Bracket, Gas Control Valve Cover Screw Valve, Gas Control (Propane Gas) Valve, Gas Control (Natural Gas) Manifold Orifice, Burner (Propane Gas) Orifice, Burner (Natural Gas) Thermocouple, 18 in. Tube, Pilot Cord, Power, 5 ft.
PAGE 16
Warranty Policy EQUIPMENT L.B. White Co., Inc. warrants that the component parts of its heater are free from defects in material and workmanship, when properly installed, operated, and maintained in accordance with the Installation and Maintenance Instructions, safety guides and labels contained with each unit. If, within 12 months from the date of purchase by the end user, any component is found to be defective, L.B. White Co., Inc.