User's Manual

http://www.L‐com.com
30
it’s STA Enrollee, credentials are created as soon as each WPS success. If it’s
STA Registrar, RaUI creates a new credential with PA2-PSK/AES/64Hex-Key and
doesn’t change until next switching to STA Registrar.
Detail–Displays Credential information in secondary pane.
Connect–Command to connect to the selected network inside credentials. The
active selected credential is as like as the active selected Profile.
Rotate–Command to rotate to connect to the next network inside credentials.
Disconnect–Stop WPS action and disconnect this active link. And then select the
last profile at the Profile Page of RaUI if exists. If there is an empty profile page,
the driver will select any non-security AP.
Export Profile–Export all credentials to Profile.
Delete–Delete an existing credential. And then select the next credential if exists.
If there is an empty credential, the driver will select any non-security AP.
PIN–Start to add to Registrar using PIN configuration method. If STA Registrar,
remember that enter PIN Code read from your Enrollee before starting PIN.
PBC–Start to add to Registrar using PBC configuration method.
Caution: When you click PIN or PBC, please don’t do any rescan within
two-minute connection. If you want to abort this setup within the interval, restart
PIN/PBC or clickDisconnect to stop WPS action.
WPS Associate IE–Send the association request with WPS IE during WPS setup.
It is optional for STA.
WPS Probe IE–Send the probe request with WPS IE during WPS setup. It is
optional for STA.
Progress Bar–Display rate of progress from Start to Connected status.
Status Bar–Display currently WPS status.
Automatically select the AP–Start to add to AP by using to select the AP
automatically in PIN method.