User's Guide

B. 1/4” Input
The ¼” input is an unbalanced (mon o), all‐discrete input.
C. 1/4” Output
The ¼” output is an unbalanced, line level output. You can plug into any amp or device that has a ¼” inp ut. We recommend
running into any other LR Baggs Align pedals, DI’s, or the Synapse Personal PA System.
Back
A. USB
This USB port is used to connect your Voiceprint DI to a computer for potential firmware updates.
B. EFX Send
Connect a standard 1/4” mono cable from this jack to the input of an effects pedal or rack device.
C. EFX Return
Connect the return of the output of an effects pedal or rack device to interrupt the signal and complete the series effect loop.
D. XLR Output
The DI out is a balanced XLR output for connecting to a mixing board with an XLR (mic) cable.
E. Ground Lift
Engage this switch to reduce or eliminate ground loop related noise.
SPECIFICATIONS
1/4” INPUT
Input Impedance: 2.2 Megohms
Input Pad: 0dB, ‐3dB, ‐6dB, ‐9dB
Input Level: ‐25dBv to +6.24dBv (.053Vrms to 2.05Vrms)
EFFECTS LOOPS
Send Level: 0dBv (0.707Vrms)
Output Impedance: 600 Ohms
Return Level: 5.2dBv (1.414Vrms) Maximum before clipping
Input Impedance: 600 Kohms
D.I. OUT
Output level: 0dBv (0.707Vrms) Balanced
Output impedance: 600 Ohms
LINE OUT
Output level: 0dBv (0.707Vrms) Un‐balanced
Output impedance: 470 Ohms
POWER
DC Power Consumption: 4.5W Max @ 9V
Voltage Range: 9VDC – 16VDC
Power Supply: 9VDC with 500mA minimum (included)
*IMPORTANT: polarity Pos (+) on outside, Gnd (‐)oncenter
Signal to Noise: 90dB, unweighted