User Manual

Marine Systems
Aviation Recorders
Rev. 06
Mar . 16/11
165M0014-10
Page 2--6
Repeated key presses will result in cycling through the character options repeatedly.
When the operator stops pressing keys for longer than the preset timeout, the last
value is retained and the cursor moves to the next location in the field. Pressing a
different key forces acceptance of the last character for the field and move s the cur-
sor along.
FNC-ENT Displays the Vessel/Voyage Setup screen.
2.1.3. Data Display Screens
The AIS interface consists of the following display screens each of which is ac-
cessed using the defined key sequence.
2.1.3.1 NAV Display Screen (Default Screen)
Figure 2--2. NAV Display Screen
This display shows the three closest targets b y MMSI number or ship name, the
range in nautical miles, and bearing of each target. Using the up ()ordown()
arrow keys you may scroll through every target that is detected.
Targets xxx: Nu mber of targets detected by the transponder.
Date: Current date.
Time: Current time derived by the internal GPS receiver.
GPS status can be found in lower right corner of display.
I = Internal Time: Valid time from the internal GPS (normal operating
condition).
S = Slot Time: Lost internal GPS time but is deriving timing inform--
ation from the slot timing on the VHF Data Link (VDL).
F= Flywheel: Transponder is depending on the internal CPU clock
for timing, after losing internal and slot timing. It will
run for approximately one minute and then go to N.
N= No time available
Display Status Indicator: A small dot flashes near the upper left corner of all
display screens during normal operation (see Figure 2--2). If the dot is not visible, or