User Manual

Page 7
110V 100mA North America
• The correct voltage and fuse rating is indicated on the
rear panel.
• Please check that your unit is correctly rated for the
voltage of the country of operation.
If the fuse requires changing at any time please ensure the correct fuse is
fitted. An incorrect fuse could cause damage to the unit and may constitute
a fire hazard.
If you carry your MPX10 from one country to another it is very important to
ensure the voltage is compatible.
For your information the unit can be internally rewired for use in 230V, or
110-125V countries - contact your dealer for information. A special 100V
version is available for Japan and a 220V version for Republic of Korea.
The mains lead connections to the appliance are coloured in accordance
with the following code:
Green-and-Yellow Earth
Blue Neutral
Brown Live
•
WARNING: THIS APPLIANCE MUST BE EARTHED
2.5 SIGNAL LEVELS
For input level ranges see GAIN control in the Description of Controls
section.
The MPX10 outputs both -10dBV and +4dBu operating levels without the
need for level switching.
++
IMPORTANT NOTE:
the XLRs are set for +4dBu and the TRS jacks
for -10dBV operating levels. Use the appropriate connector/level to
interface between your equipment and the MPX10.
The OUTPUT control on the MPX10 allows -20dB to +20dB of level
adjustment which should allow the MPX10 to interface to most equipment
types.
Signals in excess of +20dB will cause the unit to distort.
2.6 EXTERNAL CONNECTIONS