Installation & User Guide
Table Of Contents
- 1. Important safety information
- 2. Range overview
- 3. Cooking tips
- 4. Cooking table
- 5. Cleaning your range
- 6. Troubleshooting
- 7. Installation Instructions
- 8. Service and parts
- 9. Installation safety instructions
- 10. Installation
- 11. Gas connection
- 12. Conversion to LP Gas
- 13. Electrical connection
- 14. Final fitting and checks
- 15. Circuit diagram
- 16. Technical data
- 17. Warranty
INSTALLATION
Check the appliance is electrically safe and gas sound when you have nished.
23
You will also need the following tools and equipment to
complete the range installation satisfactorily.
1. Multimeter
2. Electric drill
3. Masonry drill bit & anchors (only required if installing
the range on a stone or concrete oor)
4. Steel tape measure
5. Phillips head screwdriver
6. Flat head screwdriver
7. 2.5mm, 3 mm & 8 mm Allen key (supplied with the
range)
8. Level
9. Open-end or adjustable wrench
10. Pencil and ruler
11. Pipe wrenches
12. 13 mm spanner or socket wrench
Additional materials you may need:
• Gas line shut-off valve.
• Pipe joint sealant or UL-approved pipe thread tape
with Teflon* that resists action of natural and LP gases.
*Teflon: Registered trademark of DuPont
• Flexible metal appliance connector (½’’ I. D. ). A
5foot length is recommended for ease of installation
but other lengths are acceptable. Never use an old
connector when installing a new range.
• Flare union adapter for connection to gas supply line
(¾’’ or ½’’ NPT x ½’’ I. D. ).
• Flare union adapter for connection to pressure regulator
on range (½’’ NPT x ½’’ I. D. ).
10. Installation