User Guide

8
Note: Using pans with a base diameter smaller than those
recommended will result in a power reduction.
Residual Heat Indicator, H
After use, a cooking zone will remain hot for awhile as heat
dissipates. When a cooking zone is switched o, the residual
heat indicator symbol [H ] will appear in the display. This
shows that the cooking zone temperature is above 140 °F
(60 °C) and may still cause burns. Once the temperature has
dropped to below 140 °F (60 °C) the [ H ] will go out.
Automatic Heat-up, A
This function is available on all of the cooking zones. It
allows rapid heating up of the element to bring the selected
cooking zone up to temperature. Once the zone is at the
required cooking temperature the power level will reduce
automatically to the preset level.
The function is selected by turning the control knob to the
‘A’ position. This can be selected by turning the control knob
momentarily counter-clockwise from the zero position until
the symbol [
A ] is shown on the cooktop control display.
Once the [A
] is displayed, turn the control knob to the level
of your choice (1 to 9). The pan will heat up at 100% power
for a specied time before the power is reduced to the level
selected.
When the Automatic Heat-up function is activated, the
cooktop control display will ash alternately between the [A
]
setting and the chosen power level.
Once the Automatic Heat-up time has ended, the cooktop
display will stop ashing and will show the chosen power
level.
The Automatic Heat-up function can be stopped by either
turning the control knob back to the “0” power setting or
turning the control knob to the “9” power setting.
For your guidance Table 2.2 shows the time available at
100% power depending on the power level selected in the
Automatic Heat-up mode.
Child Lock, L
To prevent the unwanted use by children, the cooktop can be
locked.
IMPORTANT: This can only be activated when all the
cooking zones are switched o.
To lock the cooktop, simultaneously turn the two left-hand
cooktop controls counter-clockwise (Fig. 2.7) and hold until
the L symbol appears in the centre of the cooktop control
display (Fig. 2.8).
Note: [A
] will ash when locking the cooktop – this is normal.
Locking the cooktop will NOT aect the oven; it can still be
used.
To unlock the cooktop, simultaneously turn the two left-
hand controls counter-clockwise and hold until the L symbol
disappears from the centre of the cooktop control display.
Power level
Automatic heat-up time at
100% (min:sec)
1 0:48
2 2:24
3 3:50
4 5:12
5 6:48
6 2:00
7 2:48
8 3:36
9
Fig. 2.7
Fig. 2.8
Table 2.2