INSTALLATION Check the appliance is electrically safe when you have finished, 10. Installation safety instructions Regulations A Installation of this range must conform with local codes, or In the absence of local codes, with the National Fuel Gas Code, ANSI latest edition. In Canada, installation must conform with the current Natural Gas Installation Code, CAN/ CG A-B149. 1 or the current Propane Installation Code, and with local codes where applicable. .
INSTALLATION Check the appliance is electrically safe when you have finished, Converting to propane gas This appliance is supplied set for natural gas. A conversion kit for Propane gas Is supplied with the range. The conversion must be performed by a qualified LP gas Installer. See the ‘Conversion’ section at the back of this installation manual for more details. A For Installation 5000 ft above sea level, the appliance must be converted using high altitude kit A065744. Contact your distributor.
INSTALLATION Check the appliance is electrically safe and gas sound when you have finished, aN Fig. . N\ Min 35% (90 an) cm) For Canada, min 36%" (92.5 cm) Maximum 13°) Min 3115 (80 cm) bi wean the top 3am TT of the cook top and a horizontal combustible surface Minimum valve Min 35%" recommended to | outlet allow for moving the range. For Canada, min 36348" (92.5 cm) es B Flg.9.2 31%" (80cm) minimum minimum Flg.9.3 44%" (112.4cm) 28%" (72.
INSTALLATION Check the appliance is electrically safe when you have finished, Recommended electrical outlet location When connecting using a NAME 14-50R receptacle, if possible position it so it can be accessed through the opening at the rear of the drawer cavity (Fig. 13.1). Alternate location within the shaded area in (Fig. 13.2). The distance between the back of the range and the wall is approximately 4° (10.6 cm). Plug the range power cord into a properly grounded wall receptacle.
INSTALLATION Check the appliance is electrically safe when you have finished, Fitting a 3-Wire Power Cord Disconnect the supplied power cord from the terminal block and ground post. Keep the terminal block parts; you will need them. Slacken the strain relief clamp from the power cord, tighten the 2 screws (Fig. 13.5) and remove the power cord. Insert the new power cord through the strain relief device but do not tighten the device yet.
INSTALLATION Check the appliance is electrically safe when you have finished, 3-Wire Conduit Installation Disconnect the supplied power cord from the terminal block and ground post. Keep the terminal block parts; you will need them. Remove the strain relief clamp from the power cord and remove the power cord and strain relief clamp from the mounting bracket. The range is shipped with reducer plates to give a 1%” diameter opening for conduit connection (Fig. 13.7). Find the reducer plates (Fig. 13.
Check the appliance is electric; INSTALLATION ally safe when you have finished. Fig. 13.12 Black Ground wire ‘White: Neutral — ee 4-Wire Conduit Installation Disconnect the supplied power cord from the terminal block and ground post. Keep the terminal block parts; you will need them. Remove the strain relief clamp from the power cord and remove the power cord and strain relief clamp from the mounting bracket (Fig. 13.11).