Installation Guide
Page 3
Page 4
Page 2
WIRELESS
TEMPERATURE
STATION
QUICK START GUIDE
DC: 101318
Full manual can be found under the Support tab here: bit.ly/308-1415bwv2
POWER UP
1. Insert 2-AA batteries into your Outdoor Sensor.
2. Insert 2-AA batteries into your Temperature Station.
3. Adjust time and date settings on the station.
4. Once the Outdoor Sensor is reading to your station, place it
outside in a shaded location.
Watch sensor mounting video: http://bit.ly/TH_SensorMounting
Outdoor Sensor
TX141-Bv3
Temperature Station
308-1415BWv2
CUS TOM DATE DISPLAY
· Press the SET button to select between full Weekday or
Calendar (Weekday, Month, Date) display.
SETTINGS
1. Hold the SET button to enter the Settings Menu.
2. Use the + or - button to adjust and SET to confirm.
Settings Menu order:
• Language (English, Spanish, French)
• Beep ON/OFF
• 12/24 Hour Time
• Hour
• Minutes
• Year
• Month
• Date
• Month/Date or Date/Month Display (see below)
• Fahrenheit/Celsius
Note: When Español or Francais is selected, the following
instructions and weekday will be presented in that language.
Note: Weekday sets automatically when Year, Month and Date are
set.
DEACTIVAT E/ ACTIVATE ALARM
• Press and release the ALARM button to deactivate or activate
the alarm. The alarm time will show for 2 seconds.
• Alarm Icon (bell) and ALARM ON will show when active
• ALARM OFF will show when inactive.
SNOOZ E
• When alarm sounds, press the ALARM button to silence alarm
for 10 minutes.
• The Alarm Icon will flash
• Press any button except ALARM to silence the alarm for 24
hours
ALARM
1. Hold the ALARM button until the Alarm Hour begins to flash.
2. Press the + or - button to adjust values, hold to adjust quickly.
3. Press the ALARM button to confirm and move to the Alarm
Minutes.
4. Use the + or - buttons again to adjust, and press ALARM to
confirm and activate the alarm.
Note: This station uses a crescendo alarm, which will increase in
volume over time. If no buttons are pressed within 2 minutes, it
MONTH/DAT E OR DATE/MONT H
• In the Settings Menu, choose Month/Date or Date/Month
calendar display.