FAQ

La Crosse Technology, Ltd Page 4
23.Press MODE to select Fahrenheit/Celsius.
24.The °F will show. Press the + or – button to select Celsius.
25.Press MODE to confirm and exit.
No WWVB Tower Icon
 The digital clock has not received a WWVB time signal in the past 24 hours.
 Position
the digital clock for better reception.
 Allow up to 5 nights to receive the time signal.
Set Time Alarm
 HOUR: Press and hold down the ALARM button for 2 seconds until the Hours
flash. Use the +/- buttons to set the Hour. Press ALARM button to confirm the
setting
 MINUTES: The Minute display of the Alarm time starts to flash. Use the +/- to
set the required minute. Press ALARM button to confirm the setting and to end
the setting procedure.
Activate/Deactivate Time Alarm
 Hold the ALARM button to enter alarm settings. “AL” will show.
 Press and release ALARM to activate/deactivate the alarm.
 The bell icon will show when active.
Note: When the alarm sounds, it will continue for two minutes then shut off.
Snooze Alarm
 When the alarm sounds, press the SNOOZE button to trigger snooze alarm for
10 minutes.
 This crescendo alarm will sound for 120 seconds if not deactivated. Press any
button to stop the alarm for 24 hours.
Digital clock has distorted or frozen display
Explanation: On a brand new digital clock, check for thin plastic film of printed
scratch guard that may be on the screen of the digital clock. This thin piece of
plastic has printed numbers for store displays. When the batteries are installed, the
“real” numbers show behind the printed scratch guard and create distortion.
 With all power removed, the digital clock should be blank.
 If numbers still appear, please check for scratch guard.
Power:
 Check that the batteries and AC cord are installed correctly.
 This is generally a power related issue.
 Batteries
may be overpowered or underpowered.
 Remove batteries from alarm clock.
 Press any button 20 times. Leave the batteries out of the display for 2 hours.
 Insert AC cord and batteries into the alarm clock.
 Insert batteries into the digital clock.
Digital clock is blank: No letters, numbers or dashed lines
 Check that the batteries and AC cord are installed correctly.
 This is generally a power related issue.
 Batteries
may be overpowered or underpowered.