Installation Guide
Page 3
Page 4
Page 2
Atomic Projection Alarm
with Indoor & Outdoor Temperature
QUICK START GUIDE
MODEL: 616146V3
DC: 080918
Full manual can be found under the Support tab here: bit.ly/616-146v3
POWER UP
1. Insert 2-AA batteries into your Outdoor Sensor.
2. Insert the 5 volt power cord into the outlet, then into your
Projection Alarm. Optional: Insert 2-AAA batteries for backup.
3. Set time, date, etc.
4. Once the sensor is reading to your station, place sensor
outside in a shaded location.
Watch sensor mounting video: http://bit.ly/TH_SensorMounting
AA
AA
TX141v3
Outdoor Sensor
616-146v3
Projection Alarm
ATOMIC TIME SIGNAL (WWVB)
SETTINGS
AAA
AAA
• The Atomic Time Signal icon (tower) will flash while searching,
and be solid when connected.
• Hold the -/TIME button anytime, to manually search for the
atomic time signal.
• The backlight and USB charging port will momentarily turn o
while the clock searches for the atomic signal.
• For information about WWVB visit: bit.ly/AtomicTime
ADJUSTABLE BACKLIGHT
• Power cord is required for constant backlight.
• Press and release the SNOOZE/LIGHT button to adjust the
backlight HI-LOW-OFF.
Note: This will adjust the projection intensity at the same time.
• If operating on battery power, press the SNOOZE/LIGHT button
to activate the backlight for 10 seconds.
1. Hold the SET/°F/°C button to enter the Setting Menu.
2. Press the +/TEMP or -/TIME button to adjust and SET/°F/°C to
confirm.
Note: Press one button at a time while in the setting menu.
Settings Menu Order:
• WWVB Atomic Time (ON/OFF)
• Time Zone
• DST Daylight Saving Time (ON/OFF)
• 12/24 Hour Time Format
• Hour
• Minutes
• Year
• Month
• Date
Note: Weekday will set automatically as year,
month and date are set.
• Press the SET/°F/°C button to select between a Fahrenheit or
Celsius temperature display.
FAHRENHEIT / CELSIUS
PROJECTION SELECTION
1. Hold the PROJECTION button to select what to project.
2. Watch the projection image to view changes, release the
PROJECTION button when on desired setting.
Projection Options:
• Time/Outdoor Temp: Alternates every 5 seconds (default)
•
Time only
• Outdoor Temperature only
PROJECTION ROTATION
PROJECTION IMAGE INTENSITY
• Press the PROJECTION button to rotate the projection
image in 90 degree increments.
• Power cord is required for a constant projection.
• Press and release the SNOOZE/LIGHT button to adjust the
projection; HI-LOW-OFF.
Note: This will adjust the backlight at the same time.
• If operating on battery power, press the SNOOZE/LIGHT button
to activate the projection for 10 seconds.