Other
La Crosse Technology, Ltd. Page 8
Time is off by hours.
This Temperature Station has manual set time.
Use the program menu to set the time.
Manually Set Time/Date: Program Menu
There are four function buttons: SET, PLUS (+), MIN/MAX, and CH. Begin by
holding the
SET button until the display flashes. When you press and release the SET button
after each step, you will move to the next step.
12H/24H Time: Press and hold the SET button and a 12 HR. or 24 HR. will
appear indicating if you want 12-Hour time or 24-Hour time. Press the PLUS (+)
button to change. Press and release SET button to move to the Hour setting.
Note: When in 24-hour mode, temperature will change from °F to °C
HOUR: The Hour will flash. Press the PLUS (+) button to change the Hour. Press
SET button again to move to the Minutes setting.
MINUTES: The Minutes will flash. Press the PLUS (+) button to change.
Note: When no buttons are pressed for ten seconds, the Temperature Station will
save the last change and default back to normal mode.
Temperature Station has missing segments.
This is generally a power related issue.
Check that the batteries are installed correctly.
Batteries may be overpowered or underpowered.
Remove batteries from Temperature Station.
Press any button 20 times. Leave the batteries out of the display for 2 hours.
Insert fresh batteries into the Temperature Station.
Temperature Station is dim.
Most Temperature Stations have a gray background. Place the Temperature
Station at eye level. Is it still dim?
Temperature Stations that sit in the sunlight can develop a cloudy film over
time.
This is generally a power related issue.
Batteries may be overpowered or underpowered. Remove batteries from
Temperature Station.
Press any button 20 times. Leave the Temperature Station unpowered for 1-2
hours.
Install fresh alkaline batteries with correct polarity.
Temperature Station has distorted display.
On a brand new Temperature Station, check for thin plastic films of printed
scratch guard that may be on the upper and lower screen of the Temperature
Station. This thin piece of plastic has printed numbers for store displays.
With all power removed, the Temperature Station should be blank.