Installation Guide

Page 3
Page 4
Page | 2
WIRELESS COLOR
FORECAST STATION
QUICK START GUIDE
MODEL: S85814v2
DC: 050420
For more product information visit: bit.ly/laxtech_support
POWER UP
1. Insert 2-AA batteries into your Outdoor Sensor.
2. Insert the 5 volt power cord into an outlet, then into your
station. Optional: Insert 3-AA batteries for backup.
3. Adjust time and date settings on the station.
4. Once the Outdoor Sensor is reading to your station, place it
outside in a shaded location.
Watch sensor mounting video: bit.ly/th_sensor_mounting
Outdoor Sensor
TX141TH-Bv3
Weather Station
S85814v2
WWVB ATOMIC TIME SIGNAL
SETTINGS
1. Hold the SET button to enter the Settings Menu.
2. Use the + or - button to adjust, and SET to confirm.
3. Press the LIGHT button anytime to exit the Settings Menu.
Settings Menu order:
• Beep ON | OFF
• Atomic ON | OFF
• Time Zone
• DST ON | OFF (Daylight Saving Time)
• Time Zone
• 12Hr | 24Hr Format
• Hour
• Minutes
• Year
• Month
• Date
• Temperature Fahrenheit | Celsius
Atomic OFF: When Atomic OFF is selected, you will skip items
“Time Zone” and “DST” and go straight to 12/24 hour time
format.
Weekday: Weekday sets automatically when Year, Month and Date
are set.
Setup Video: If you’re more of a visual learner, please see our
Complete Setup Guide video here: bit.ly/S85814_setupguide
• The station will automatically search for the atomic time signal at
UTC 7:00, 8:00, 9:00, 10:00, and 11:00.
• The Atomic Time Signal Icon will flash while searching, and be
solid when connected.
• Press the SEARCH button anytime, to manually search for the
atomic time signal.
• For information about WWVB visit: bit.ly/AtomicTime
ADJUSTABLE BACKLIGHT
• Press and release the LIGHT button to adjust the Backlight:
HI-LOW-OFF.
• When operating on batteries only, press the LIGHT button for a
10 second backlight.
TIME ZONE
AST
EST
CST
MST
PST
AKT
HAT
ALERTS
To set alerts:
1. Hold the ALERTS button to enter the Alert Set Mode.
2. The Outdoor LO temp alert will begin flashing. Use the + or -
button to arm (ON) or disarm (OFF) the alert. Press the ALERT
button to confirm.
3. If an alert is armed (ON), its alert value will begin flashing. Use
the + or - button to adjust the alert value, and the ALERTS
button to confirm.
4. Press the LIGHT button anytime to exit.
When Alert Sounds:
• When armed alert value is reached, station will beep 5 times
each minute, until out of alert range.
• The flashing Alert Icon will indicate if it is a LO or HI alert.
• Press any button to stop the alert sound. The Alert Icon will
continue to flash while the value is in the alert range.
LO
HUMIDITY
LEVEL
HUMIDITY
LO
OUTDOOR
HUMIDITY
LEVEL
HUMIDITY
LO
OUTDOOR