User's Manual

The wind station will accommodate up to two additional

thermohygro sensors (TX141TH-BCH ) on channels 2 and 3.

Note: The TX141W sensor must be on channel 1.

Press the button to view sensors on other channels.

Setup additional sensors to the wind station:

1. Remove the battery cover from all the sensors

(leave battery covers o until all sensors are received

by the wind station).

2. Set the rst additional sensor to Channel 2 and insert

2 AA batteries.

3. Set the second additional sensor to Channel 3 and insert

2 AA batteries.

4. Hold the button on the wind station for 5 seconds to

search for sensors.

5. Press the TX button on each sensor.

6. When connection is established, the temperature &

humidity for each of the selected channels will appear.

7. Install the battery covers on each sensor.

8. Keep sensors and the wind station 5-10 feet apart for 15

minutes to establish a solid connection.

9. After 15 minutes, place the remote sensors in appropriate

shaded locations.

10. Press and release the button to view channels 1, 2 or 3 on

the wind station when multiple sensors are used.

Note: If only one sensor is connected, the other channels will

show dashes for temperature and humidity.

Page | 13 www.lacrossetechnology.com/support Model: 327-1414W

Setup Add On Temperature/Humidity Sensors

Channel Indicator

• Press the button to toggle between remote sensor channels when multiple

sensors are used.

Channel Auto Scroll

• The wind station will automatically rotate through the channels for all

connected sensors.

• Press and release the button to lock the wind station into one channel.

• Then press the button to view channels individually.

1 2 3