WS-9004U 915MHz WIRELESS RAIN GAUGE INSTRUCTION MANUAL
CONTENTS 03 03 04 06 07 08 09 09 10 introduction features setting up function keys operations maintenance specifications liability disclaimer warranty information 2
INTRODUCTION Thank You and Congratulations on your purchase of this innovative Wireless Rain Gauge for display of rainfall data through a wireless rainfall sensor. With 2 easy to use function keys, this unique product is perfect for gardeners and weather buffs alike. This product offers: INSTANT TRANSMISSION is the state-of-theart new wireless transmission technology, exclusively designed and developed by LA CROSSE TECHNOLOGY.
SETTING UP Hint: Use good quality Alkaline Batteries; avoid rechargeable batteries. 1. Have the receiver and the rain gauge 3 to 5 feet apart. 2. Place the batteries into the rain gauge FIRST and next into the receiver. Observing the correct polarization, insert 2 “AAA” Alkaline Batteries into the compartment at the back of the rain gauge and replace the cover. Follow the same guidelines for the receiver.
Battery Compartment Battery Cover Receiver 3. DO NOT PRESS ANY BUTTONS FOR 15 MINUTES. 4. All segments of the LCD will light up briefly. Then 0.00 inch will be displayed in both sections of the LCD. If the “0.00” is not displayed after a few seconds, remove the batteries and wait for at least 10 seconds before reinserting them. 5. Place the rain gauge in an appropriate location.
This allowance is typically enough for a frame wall with nonmetallic siding; however certain materials can reduce range even further. Metal siding, stucco, and some types of glass can reduce signal range by as much as ¾ or more, compared to the ½ reduction typical of most obstructions. It is possible to receive a signal through these materials, however maximum range will be much less due to their tendency to absorb or reflect a much larger portion of the sensor’s signal.
• To view the alarm pres and hold the ALM/SET button. This will cause the receiver to beep if the set alarm value has already been reached. Resetting TOTAL RAINFALL and 24 HOUR RAINFALL • Total Rainfall: Press and hold the RESET/+ button. The receiver will beep, and the total rainfall will reset to 0.00”. • 24 Hour Rainfall: To reset the 24 Hour Rainfall to “0.00”, remove the batteries, wait 2 minutes, and then re-insert the batteries. Note: The 24H Rainfall will not reset to “0.00”.
Foldout Table Stand The foldout table stand is located on the backside of the Receiver. Carefully pull out the stand and place the Receiver in the desired location. Wall Mounting Place a screw in the desired location leaving the head extended about ¼” from the wall. Hang the Receiver on the screw ensuring that the Receiver locks into place. Hanging Hole Hanging Hole Table Stand Positioning the Rain Gauge Position the connected rain gauge outdoor to collect rainfall data.
Top View Holes for screws Side View MAINTENANCE • Avoid placing the units in locations prone to extreme temperatures, vibration and shock since these may cause damage and inaccurate readings. • When cleaning the display and casing of the Wireless Rain Gauge, use a soft damp cloth only. Do not use solvents or scouring agents as they may mark the casing and LCD. • Do not submerge the Wireless Rain Gauge in water. • Immediately remove all low powered batteries to avoid leakage and damage.
SPECIFICATIONS Rainfall Rainfall Alarm Rainfall Range Unit Display Transmission Range Transmission User defined from 0.05” to 4.00” over 24 hour period 0.00” to 199.99” (total) (“OFL” displayed if outside this range) 0.00” to 9.98” “(24H)) (“OFL” displayed if outside this range, or if rainfall recorded is greater than 5.00” within 2 hours) Inch 330 Feet 915 MHz, updating every 6 seconds Power Supply: Receiver: Rain Gauge: Battery life cycle: Recommended battery type: 2 x AAA, IEC LR3, 1.5V.
• • This product is not a toy. Keep out of the reach of children. No part of this manual may be reproduced without written consent of the manufacturer. WARRANTY INFORMATION La Crosse Technology, Ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and workmanship. This limited warranty begins on the original date of purchase, is valid only on products purchased and used in North America and only to the original purchaser of this product.
Phone: 507.895.7095 Fax: 507.895.2820 e-mail: support@lacrossetechnology.com (warranty work) sales@lacrossetechnology.com (information on other products) web: www.lacrossetechnology.com Questions? Please see instruction video at: www.lacrossetechnology.info/9004 All rights reserved. This handbook must not be reproduced in any form, even in excerpts, or duplicated or processed using electronic, mechanical or chemical procedures without written permission of the publisher.
