Full Product Manual

Page | 19Wireless Remote Monitoring Wind Station

LTV-TH1 Thermo-Hygro Sensor

1. Install 2-AA batteries according to polarity and replace battery cover.

Mounting:

1. Use the hole at the top to hang your sensor from the back using a nail. Or, insert one mounting screw through

the front of your sensor.

2. Mount your sensor on a north-facing wall or in any shaded area. Under an eave or deck rail is preferred.

3. The maximum wireless transmission range to the weather station is up to 400 feet (121 meters) in open air,

not including walls or ﬂoors.

4. Be sure your sensor is mounted vertically, to allow moisture to drain out properly.

Note: Watch sensor mounting video: http://bit.ly/TH_SensorMounting

1. Insert the power cord into a wall outlet, then into your station.

Optional: Insert 3 AA batteries into your station to maintain time/date in the event of a power outage.

Mounting:

1. Place your station near an outlet. Power cord is required for operation.

2. Use the mounting holes on the back to place your station on a wall.

3. Use the pull down stand on the back of your station to place on a desk or counter.

4. Your station should remain in good Wi-Fi range of your wireless router to use all the remote monitoring

options using the La Crosse View™ app.

For more information on manually setting you weather station see page 10.

Power

Cord

Optional

Hole for

mounting

LED Light

Battery Cover

∙ Press TX to

send a signal