Installation Guide

11.5” Atomic Wall Clock

Model: W85961

DC: 021017

Power up

Select Time Zone and DST ON or OFF.

Insert 1 AA battery into the movement.

For best reception, place clock on a wall that

faces Ft. Collins, Colorado.

During the night, your clock will set itself.

For information about WWVB, atomic time signal visit:

http://bit.ly/AtomicTime

IMPORTANT:

• Hands will move to 12:00 and search for the

atomic time signal.

• If no signal, after 8-10 minutes, clock will run

from 12:00 am.

• Clock will continue to search for the WWVB

atomic time signal.

• Allow up to 5 nights for the clock to receive

the atomic time signal.

PAGE 1
Power up 1. Select Time Zone and DST ON or OFF. 11.5” Atomic Wall Clock 2. Insert 1 AA battery into the movement. 3. For best reception, place clock on a wall that faces Ft. Collins, Colorado. 4. During the night, your clock will set itself. IMPORTANT: • Hands will move to 12:00 and search for the atomic time signal. • If no signal, after 8-10 minutes, clock will run from 12:00 am. • Clock will continue to search for the WWVB atomic time signal.
PAGE 2
1 2 3 4 5 6 1 SET 2 WAVE (Atomic search) 3 RESET 4 Battery 5 Time Zone Selector 6 DST Selector Set the clock manually: 1. Hold SET for 3 seconds 2. Press and Hold SET to move hands quickly. 3. Press and release SET to move hands forward step by step. 4. The atomic time signal will override manual settings. Reset: If the clock does not respond to function modes, press the RESET button on the movement case.