Model: WS-9133U-IT Quick Setup Guide DC: 041916 WIRELESS FORECAST STATION Time 12/24hr + Alarm Forecast Icon + Tendency Arrow Indoor Temp. ºF/ºC Outdoor Temp. ºF/ºC TX37U-IT Temperature Sensor Wall Hanging Hole Battery Compartment 3AA batteries 2 “AA” batteries Pullout Stand BUTTONS SET + ALARM MIN/MAX RESET WS-9133U-IT www.lacrossetechnology.
Get Started 1: Insert 2 fresh AA, LR6 1.5 volt batteries into the TX37U-IT sensor according to the polarity marked in the battery compartment. 2: Insert 3 fresh AA, LR6 1.5 volt Alkaline batteries into the forecast station according to the polarity markings. 3: After 5 minutes place sensor outside in a shaded location. Restart: If the outdoor temperature shows dashes, remove batteries from the station & outdoor sensor. Press any button on the station 20 times. After 15 minutes, return to #1.
Snooze • • Press the MIN/MAX button to activate the snooze function for 10 minutes. To stop the alarm completely, press any button other than the MIN/MAX button. Forecast Icons The forecast station uses changing atmospheric pressure to predict weather conditions for the next 12-hours with 70-75% accuracy. Sunny Partly Sunny Rainy Forecast Trend Arrows The up or down arrow indicate current trends in air pressure. Up Arrow: Air pressure is increasing; weather will improve.
Position Outdoor Sensor • • Mount the outdoor sensor on a north-facing wall or in any well shaded area. Under an eave or deck rail is preferred. The maximum transmitting range to the wireless forecast station is over 330 feet (100 meters) in open air, not including walls, tree, windows etc. Specifications Indoor: Temperature Range: 14.2°F to 99.9°F (-9.9°C to 37.
Care and Maintenance • • • • • • • • Do not mix old and new batteries Do not mix Alkaline, Standard, Lithium or Rechargeable Batteries Always purchase the correct size and grade of battery most suitable for the intended use. Replace all batteries of a set at the same time. Clean the battery contacts and also those of the device prior to battery installation. Ensure the batteries are installed with regard to polarity (+ and -).
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.