Instruction Manual

WS6205 Instruction Manual
about 2 seconds. This will reset all minimum and maximum data recorded to the current displayed values.
F.Y.I.:
 If the temperature reading is below ranges, the LL.L will be displayed. If the temperature reading is above
ranges, the HH.H will be displayed.
OUT Remote Temperature alert setting
 Press and hold down the “ ” button for 2 seconds until the icon for the Temperature Alert” starts to flash
 The icon of Upper limit of the Temperature alarm starts to flash. Use the “+” and “-” buttons to set the
required maximum temperature. Press “
” to confirm your setting.
 The icon of the Lower limit of the Temperature alarm starts to flash. Use the “+” and “-” buttons to set the
required minimum temperature. Press “ ” button to confirm your setting and to end the setting
procedure
F.Y.I.:
 Before entering the setup, you must select the remote channel, different channels can set different
temperature alarm range
Temperature and frost alert
 Press “ ” button to activate or deactivate the remote temperature alert, When the remote temperature
alarm is activated, the temperature alarm icon is displayed in the remote sensor bar
 When the remote channel temperature value exceeds the set temperature range, will activate the alarm, the
weather station will every minute continuous alarm 5 times, at the same time, temperature alarm in alarm
icon "
" flashes, If the alarm activates the temperature that is currently displayed on the channel, its
temperature value and alarm upper limit icon “ "or lower limit icon" " also flashes
 When the temperature of remote SENSOR is –1°C to + 3°C or +30°F to + 37°F, the frost alarm will be
activated,
symbol "
" flashing.
F.Y.I.:
 When the temperature is higher than the upper limit of the alarm temperature setting, the activation of the