Clock User Manual

2. Set the desired hours by pressing and releasing the + key followed by pressing the SET

key.

3. Now the minute digits will start flashing.

4. Set the desired minutes by pressing and releasing the + key. If the + key is held, the units

will increase by 5.

5. Press and release the SET key to move to the “Year Setting”.

Note:

The unit will still try to receive the signal every day despite it being manually set. When it does

receive the signal, it will change the manually set time into the received time. During reception

attempts the WWVB tower icon will flash. If reception has been unsuccessful, then the WWVB

tower icon will not appear but reception will still be attempted the following hour.

WWVB time reception takes place from 12:00 am through 6:00 am each day (attempts WWVB

reception every full hour within this time frame). When the time signal is received for example at

1:00 am, the radio-controlled clock will not attempt to receive the WWVB signal for the

remaining hours until 6:00 am. Therefore, the next signal attempt will take place between 12:00

am and 6:00 am the next day. The other times WWVB reception takes place, are upon setup

and after manual time set exiting mode. Reception is generally not possible during daylight

hours due to the interference of the sun.

YEAR SETTING

The year can be selected sequentially from 2003 to 2029 and will then start over again (default

setting 2005). Only the last 2 digits of the year will be visible on LCD2. The year will only

appear in the manual setting mode.

1. The year digits will start flashing on LCD2. Select the desired year by use of the + key.

2. Press and release the SET key to switch to the “Month Setting”.

MONTH SETTING

1. The month digits on LCD2 will start flashing. Set the desired month by use of the + key.

2. Press and release the SET key to move to the mode “Date Setting”.

DATE SETTING

1. The digits for the date will start flashing on LCD2 (Default setting 1). Set the desired date

by use of the + key.