Installation Guide

12 “ Atomic Wall Clock

Model: WT-312Bx1

DC: 101316

Power up

Select Time Zone and DST ON or OFF.

Insert 1 AA battery into the movement.

OPTIONAL: Insert 2 AA batteries in the side

compartments, for up to 3 year battery life.

For best reception, place clock on a wall that faces

Ft. Collins, Colorado.

During the night, your clock will set itself.

IMPORTANT:

• Hands will move to 12:00 and search for the

atomic time signal.

• If no signal, after 8-10 minutes, clock will run from

12:00.

• Clock will search for atomic time signal again, after

midnight, when signal is strongest.

• Allow up to 5 nights for the clock to receive the

atomic time signal.

For information about WWVB, atomic time signal visit:

www.nist.gov/pml/div688/grp40/wwvb.cfm

PAGE 1
Power up 1 Select Time Zone and DST ON or OFF. 12 “ Atomic Wall Clock 2 Insert 1 AA battery into the movement. OPTIONAL: Insert 2 AA batteries in the side compartments, for up to 3 year battery life. 3 For best reception, place clock on a wall that faces Ft. Collins, Colorado. 4 During the night, your clock will set itself. IMPORTANT: • Hands will move to 12:00 and search for the atomic time signal. 84 • If no signal, after 8-10 minutes, clock will run from 12:00.
PAGE 2
1 2 3 4 5 6 1 SET 2 WAVE (Atomic search) 3 RESET 4 Battery 5 Time Zone Selector 6 DST Selector Set the clock manually: 1 Hold SET for 3 seconds 2 Press and Hold SET to move hands quickly. 3 Press and release SET to move hands forward step by step. 4 The atomic time signal will override manual settings. Reset: If the clock does not respond to function modes, press the RESET button on the movement.