Atomic Digital Alarm Clock with Indoor | Outdoor Temperature For online video support: http://bit.
Table of Contents ........................................................... 2 .............................................................. 2 Buttons Setup .................................................. 3 ..................................................... 3 ......................................................... 3 Settings Menu Atomic Time Backlight ....................................... 4 ........................................................
Buttons SNOOZE Setup 1. Install 2-AA batteries into the TX37U-IT sensor. 2. Insert the 4.5 volt power cable into a wall outlet, then into the bottom of the clock. Power cord required for projection to stay on. Optional: Insert 3-AA batteries into the back of the station. 4. Keep sensor and clock within 5 feet for at least 15 minutes after installing batteries. This allows the sensor and clock to sync properly and ensures a strong connection. 5.
Settings Menu 1. Hold the MODE/MIN button to enter settings menu. 2. Press the SNOOZE button to confirm adjustments and move to next item. 3. Press the AL/HOUR or MODE/MIN button to adjust values. Note: • When setting time (hours and minutes flash together): o Use the AL/HOUR button to set the hour. o Use the MODE/MIN button to set the minutes. • When setting the calendar (month and date flash together): o Use the AL/HOUR button to set the month. o Use the MODE/MIN button to set the date.
Clock Display Features Press and release the MODE/MIN button to change what is displayed below the time. • Temperatures • Seconds • Alarm Time • Calendar TEMPERATURES SECONDS ALARM TIME CALENDAR Set Alarm 1. Hold the AL/HOUR button to enter alarm settings. 2. Press the AL/HOUR button to adjust the hour, and MODE/MIN button to adjust the minutes. 3. Press the SNOOZE button to confirm adjustments and exit, or wait 30 seconds without pressing buttons to return to the normal time display.
Projection Brightness | Turn Off Tip: You must be powering the alarm with the provided power cord for the projection to function Press and release the Brightness (sun) button to change the brightness of the projected image: • High • Medium • Low • OFF Projection Time | Temperature • The clock will alternate projecting the time and the outdoor temperature every 5 seconds. • The alternating time and temperature cannot be adjusted to just time, or just temperature projected.
Mount Outdoor Sensor • Mount the Outdoor Sensor on a north-facing wall or in any well shaded area. Under an eave or deck rail is preferred. • The maximum wireless transmission range to the weather station is over 330 feet (100 meters) in open air, not including walls or floors. • Be sure the outdoor sensor is mounted vertically. Restart If the outdoor temperature is showing dashes: • Bring the sensor in the house five feet from the station.
Care and Maintenance • • • • • • • • Do not mix old and new batteries. Do not mix Alkaline, Standard, Lithium, or Rechargeable Batteries. Always purchase the correct size and grade of battery most suitable for intended use. Replace all batteries of a set at the same time. Clean the battery contacts and also those of the device prior to installation. Ensure the batteries are installed with correct polarity (+ and -). Remove batteries from equipment when it is not used for an extended period of time.