DPV212CRB/ DPV212R / DPV212OR / DPV212W /DPV212N REFRIGERATOR
2
GB Table of Content Product Features Installation Instruction Safety Preaction Maintenance & Cleaning Troublshooting 3
Read the instruction carefully. To avoid any risk of personal injury, material damage or incorrect use of the appliance, be sure to observe the following safety precautions. (After reading these owner’s instructions, please keep them in a safe place for reference). Remember to hand them over to any subsequent owner.
-‐ Automatic fridge defrost. The defrost water flows into a tray suituated on the compressor from which it evapoates by the heat generated during the process od refrigeration.
Warning When you install your refrigerator, it is important to bear in mind the climatic rating of the appliance. In order to find out the climatic rating of your appliance, check the data rating plate.
accepted if the appliance is not earthed in accordance with the national standards rules presently in force.
Installation Instruction: 1. The appliance cannot tilt more than 45 degrees when you move it. Do not put force on any part as the condenser, the door and handle. It will be deformed surfaces or disrupt the operation of the refrigerator. 2. Make sure there is enough space around refrigerator.
8.
prevent cross-‐flavouring. • Never let any oil or grease come into contact with the plastic fittings or door seals, as these materials easily become porous.
5. Replace the light cover in the old location and click to put in place. 6. Reconnect the refrigerator to the electrical outlet and switch on. Operation preaction 1. Ensure the supply voltage of scoket are same as rating label. 2. The plug must be completed inserted to the wall socket. 3.
4. Defrost the freezer when the layer of ice on the walls reaches 3-‐4 mm. During thawing, remove the food, set the thermostat at level 0 and open the door. When the ice has melted, remove water and dry the interior walls of the refrigerator. Then reset the thermostat to the desired level and restart the machine.
Troubleshooting 1. If the refrigerator does not run: make sure that Check the supply voltage is supplied Check that the power plug is correctly connected. 2. If the refrigerator does not become cold enough: make sure that -‐ The thermostat is set too low -‐ There is enough space around the refrigerator.
Disposal The European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), requires that old household electrical appliances must not be disposed in the normal unsorted municipal waste stream.
OK Correct setting Temperature too high, adjust the refrigerator temperature control.
Power Saving Tips • Install the appliance in a cool, dry room with adequate ventilation. Ensure that it is not exposed to direct sunlight and never put it near a direct source of heat (radiator, for example). • Never block any vents or grilles on the appliance. • Allow warm food to cool down before placing it in the appliance.