Use and Care Manual

LIGHTING & REFUELLING
• This product is ONLY suitable for use with untreated wood or logs.
• Prepare a stack of loosely crumpled newspaper and place on top of the log grate.
• Pile finely split dry firewood or kindling on top of the paper.
• To light the newspaper, use long safety matches or a long nosed lighter.
• Once sufficiently alight, add logs or larger pieces of untreated wood to the unit to increase the heat slowly.
• DO NOT overload with fuel, only one or two logs is sufficient.
• ALWAYS use heat resistant gloves when adding fuel as the unit will become very hot. .
• ALWAYS ensure that fuel does not protrude from the front opening of the product.
EXTINGUISHING
• To extinguish – stop adding fuel and allow fire to die or douse with sand. DO NOT use water as this
may damage the product.
STORAGE
• When not in use, and if stored outside, cover the product once it has cooled completely with a weatherproof
cover.
• Remove loose paint and rust with a wire brush when needed and re-paint the product using high temperature
paint.
3
Careandsafeuseguidelines
DO NOT overload with fuel, only
one or two small logs is sufficient.
For safety reasons, always inspect your
chimenea prior to use for signs of fatigue
and damage and replace your model as
and when necessary.
Always use heat resistant gloves
during use and when adding fuel.
DO NOT use alcohol, intoxicants, narcotics
or any form of non-prescription drug when
handling the product as the ability to safely
assemble and operate will be impaired.
To extinguish unit – stop adding fuel
and allow fire to die or douse with
sand.
DO NOT use water as this may
damage the chimenea.
Use care when working near fire, do not stand
over fire when lighting or during use, loose
clothing can catch fire easily. If clothing catches
fire always remember to stop, drop and roll.
Parts list
8 (3x)
9 (1x)
A (3x)
M5 bolt
M6 bolt
B (12x)
1 (1x)
3 (1x)
2 (1x)
4 (1x)
5 (1x)
7 (1x)
6 (1x)
WARNING - DO NOT over tighten bolts; only tighten with moderate pressure to avoid damaging the bolts or
components of the chimenea.
Prior to assembly, read the instructions carefully. Check all parts against the parts list.
Carry out assembly on a soft surface to avoid scratching the paint. Please retain this information for future reference.
For ease of assembly only loosely tighten bolts and then tighten fully when assembly is complete.
C (12x)
If the chimenea surface becomes scratched
or chipped, the damaged area should be
re-coated with a suitable non-toxic high
temperature paint.