Use and Care Manual

3
Care and safe use guidelines
LIGHTING & REFUELLING
• This product is ONLY suitable for use with charcoal, untreated wood or logs.
• Prepare a stack of loosely crumpled newspaper and place in the bottom of bowl.
• Pile finely split dry firewood or kindling on top of the paper.
• To light the newspaper, use long safety matches or a long nosed lighter.
• Once sufficiently alight, add logs larger pieces of untreated wood to the unit to increase the heat slowly.
• DO NOT overload with fuel, only one or two logs is sufficient.
• ALWAYS use heat resistant gloves when adding fuel as the unit will become very hot.
COOKING ON YOUR FIREBOWL
• Add 0.5 kg of charcoal in the bottom bowl and light according to the instructions.
• It is recommended that the unit is heated up and the fuel kept red hot for at least 30 minutes prior to first cooking on the unit.
• DO NOT cook before the fuel has a coating of ash.
• If refuelling is required, ALWAYS use heat resistant gloves.
FOOD COOKING INFORMATION
• DO NOT cook before the fuel has a coating of ash.
• ALWAYS wash your hands before and after handling uncooked meat and before eating.
• ALWAYS keep raw meat away from cooked meat and other foods.
• Before cooking ensure grill surfaces and tools are clean and free of old food residues.
• DO NOT use the same utensils to handle cooked and uncooked foods.
• Ensure all meat is cooked thoroughly before eating.
• CAUTION – eating raw or under cooked meat can cause food poisoning (e.g. bacteria strains such as E.coli).
• To reduce the risk of under cooked meat cut open to ensure it is cooked all the way through.
• CAUTION – if meat has been cooked sufficiently the meat juices should be clear and there should be no traces of pink/red juice
or meat colouring.
• Pre-cooking larger pieces of meat and joints is recommended before finally cooking on your grill.
• After cooking ALWAYS clean the grill cooking surfaces and utensils.
EXTINGUISHING
• To extinguish, stop adding fuel and allow fire to die or douse with sand. DO NOT use water as this may damage the product.
STORAGE
• When not in use, and if stored outside, cover the product once it has cooled completely with a weatherproof firebowl cover.
• Remove loose paint and rust with a wire brush when needed and re-paint the product using non-toxic high temperature
paint.
Careandsafeuseguidelines
DO NOT use water as this may
damage the product.
DO NOT overload with fuel, only
one or two small logs is sufficient.
Use care when working near fire, do not stand
over fire when lighting or during use, loose
clothing can catch fire easily. If clothing catches
fire always remember to stop, drop and roll.
For safety reasons, always inspect your
product prior to use for signs of fatigue
and damage and replace your model as
and when necessary.
To extinguish unit – stop adding fuel
and allow fire to die or douse with
sand.