Cod. 2850018 - Rev.
INTRODUCTION Dear Customer, Thank you for choosing our product. This machine, thanks to its reliability, will be able to win your preference also for other products in our range. Each dealer will be able to refer you to the nearest Service Centre. Notwithstanding the ease of use of the machine, in order to get the best results it is important to thoroughly read this booklet and follow all instructions before starting the machine.
IMPORTANT PRECAUTIONS SAFETY REGULATIONS When using electric material it is important to ensure the appropriate precautions are adopted in order to avoid electric shock, accidents and damage to persons and things. Make sure to implement all necessary precautions to avoid contact of the machine with liquids. Liquids can seep inside the machine and cause shortcircuits or energise external parts of the machine.
•Check that the power supply cable is not damaged or defective. If there is a problem, do not use the machine under any circumstances. The power supply cable must be replaced by the manufacturer or by one of its service centres.
OPERATING INSTRUCTIONS CONTROL PANEL F03 F09 1 2 3 3 3 4 5 6 7 8 Drip tray Cup support grille Canister of product A Canister of product B Canister of product C Door Water level sensor Water tank Main switch Control panel The figure shows the F09, which has 3 canisters.
PRELIMINARY OPERATIONS • As indicated in the figures of the previous page, the machines have 2 dispensing buttons for each granulated product: - Large cup: long dose - Small cup: short dose In addition, they have a rinse button for each mixer unit installed. The name assigned to the buttons in the figure (e.g. A1-A2), indicates the name of the controlled mixer unit, A is the first one from the left.
STARTING THE MACHINE N.B.: the machine requires little time for heating, if not used in the immediate future, it is advisable to switch it off. For correct dispensing, it is important that the product inside the canister never falls below this level. After completing the preliminary operations, place a large enough container in the drink dispensing point. NOTE: the different configurations of the machine allow one or more dispensing points.
Pay attention now, the display will indicate the message “READY SEL.PRODUCT“ and at this point it will be possible to dispense the desired drink by pressing the corresponding button. INSTRUCTIONS FOR ROUTINE CLEANING In order to keep the machine efficient and ensure a long lasting duration, it is sufficient to take some simple precautions. When switching the machine on, every now and then during the course of the day and before switching it off, clean the mixer by pressing the rinse button.
TROUBLE-SHOOTING • The machine dispenses too little water: replace the resin filter fitted on the water intake tube and located inside the water tank. • The machine dispenses one drink and then stops: check the water level in the tank and if necessary refill it or verify that the shut-off valve is open. • The powder is not dispensed: check that the product canister is correctly inserted in its seat and/or there is sufficient product.
