Operation Manual

33
INSTALLATION INSTRUCTIONS
Before Using Your Wine Cooler
Remove all exterior and interior packing.
Before connecting the Wine Cooler to the power source, let it stand upright for approximately 24 hours.
This will reduce the possibility of a malfunction in the cooling system caused by handling during transportation.
Clean the interior surface with lukewarm water using a soft cloth.
INSTALLATION OF YOUR WINE COOLER
This device is not designed to be incorporated into fitted kitchen units
The appliance should be positioned in a well-ventilated, dry room.
Place your Wine Cooler on a position that is strong enough to support it when it is fully loaded. To level your Wine Cooler, adjust
the front leveling leg at the bottom of the Wine Cooler.
This appliance must be fixed at the top and the bottom using the rail provided for the purpose in order to avoid any risk of tipping
when the shelves are slid out
Locate the Wine Cooler away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the
acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the
unit not to perform properly.
Plug the Wine Cooler into an exclusive, easily accessible plug socket. Any questions concerning power and/or earthing should be
directed towards a qualied electrician or an authorized products service centre.
To prevent the appliance from heating up, ensure that an adequate ventilation gap is retained and install a suitable thermal
insulation panel. An adequate flow of air to and from the cooling system must be ensured.
The appliance must be installed to all electrical, plumbing, water and drain connections in accordance with state and local codes.
Please note in first time use, there will be alarming right after plugging which is caused by wrong humidity and temperature.
Without running power, the humidity and temperature may be out of the setting range(40-80%, 5-20 degree). You can press any
key to stop the alarm.
Room temperature
The climate class is stated on the name plate. This specifies the optimum room temperature. Wine coolers with winter position,
however, function at room temperatures as low as 5°C.
Climate class
Optimum room temperature
SN
+10~+32
N
+16~+32
ST
+18~+38
T
+18~+43