Owner's manual

8" - 14 gauge spun aluminum ball
gold anodized
Single sheave truck, cast aluminum
revolving, non-fouling type
2 Bronze swivel snaps with covers
per halyard
1 Set of halyard: #10 poly
1 - 9" Cast aluminum cleat
Aluminum flash collar
3000 PSI concrete
Hardwood wedges
(supplied by others)
Dry sand tightly tamped
after aligning pole
Foundation sleeve -16 ga
hot dip galvanized steel
Steel centering wedges
1/4" Steel base plate
1/4" Steel support plate
welded to grounding spike
All shafts with overall
length of more than
38'-6" are shipped in
two sections.
Each section matched marked
for field assembly. Exposed
portion of jam sleeve must
be well lubricated prior to
assembly.
1-1/2" maximum shop
gap allowed for field fitting
(ram for tight joint)
Tapered portion: 20'-0"
Straight portion: 18'-6"
Project:
Location:
Architect:
Contractor
Customer:
Date:
Revision:
Job:
Overall length: 38'-6"
Foundation: 4'-0"
Cleat height: 5'-0"
Truck Detail
Aluminum body
Stainless steel ball bearings
Aluminum sheave
Cast aluminum spindle
Model EC35
8"
16"
35"
12"
6"
Exposed height: 35'-0"
Ground set tapered aluminum flagpole: ALLOY: 6063T6
Exposed height: 35'-0"
Overall height: 38'-6"
Ship in 1
section
Butt diameter: 7"
Top diameter: 3-1/2"
Wall thickness: .188"
Finish: 100
grit polish
3'-6"