Install and Operating Manual User guide

LAARS Heating Systems
Page 38
13.2 Parts List
ITEM DESCRIPTION SIZE 125
PANEL ASSEMBLIES – See Figures 27-30
1 Panel, front, top, assy 12H3005
1A Panel, top, upper 12H7001
1B Screw, captive, .19 x .54 fast lead, phil pan hd F2028100
1C Screw, #8-32 x 3/8", phil pan hd F2027100
1D Gasket, strip, foam, adhesive, 3/8 x 1/8 S2113900
1E Panel, front, top, subassy 12H3015
1F Washer, retaining, .50 OD, nylon F2028200
2 Panel, front, middle, assembly, LMH 12H3003
Panel, front, middle, assembly, LMC 12H3033
2A Panel, front, middle, plastic 12H7002
2B Gauge, press/temp, remote A2117600
2C Switch, Rocker, 120V, amber E2335000
2D Display module, electronic RE2333500
2E Hinge, front panel, middle 12H3008
2F Circuit Breaker, 10 Amp, 120V E2318900
2G Circuit Breaker, 2A, 120V E2335100
2H Support, middle panel 12H3017
2I Screw, #6 x 3/8" thd forming for plastic 1-418
2J Screw, #8-32 x 3/8", phil pan hd F2027100
2K Rivet, pop, 3/16 diameter F2015900
2L Latch, magnet, .56 dia, 3.1 lbs F2028300
2M Harness, wire, power switch/circuit breaker E2334501
2N Harness, wire, display/+24V circuit breaker E2334502
3 Panel, front, bottom, assembly 12H3004
3A Control, programmed 12H7050
3B Bracket, mounting, control 12H7004
3C Panel, front, bottom, plastic 12H7003
3D Hinge, front panel, bottom 12H3007
3E Rivet, pop, 3/16 diameter
3F Screw, #8-32 x 3/8", phil pan hd
3G Washer, retaining, .50 od, nylon
3H Screw, captive, .19 x .54 fast lead, phil pan hd
4 Panel, left side 12H3019
5 Panel, right side 12H3018
SECTION 13.
Replacement Parts
Use only genuine LAARS replacement parts.
13.1 General Information
To order or purchase parts for the LAARS Mascot II, contact your nearest LAARS dealer or distributor. If
they cannot supply you with what you need, contact Customer Service (see back cover for address, telephone
and fax numbers).
ITEM DESCRIPTION SIZE 125
BASE JACKET ASSEMBLY - see Figure 31
6 Base, jacket, assembly 12H3001
6A Base, jacket 12H3011
6B Screw, 8-32unc x 1.5l F2001900
6C Bracket, wall attach 12H3012
6D Screw, hex head, 1/4-20 unc x .75" lg. F2011600
6E Nut, ange, serrated, hex head, 1/4" 10-103
6F Bracket, hx, right side 12H3010
6G Bracket, hx, left side 12H3016
6H Screw, #8-18 x 1/2, phil pan hd F2027000
6I Switch, pressure, air/gas, inlet E2334900
6J Transformer,40Va, 115V/24V R0021300
6K Bracket, transformer 12H3009
6L Rivet, pop, 3/16 diameter F2015900
HEAT EXCHANGER CABINET - see Figure 32
7A Grommet, pipe, wire, multi size, rubber S2114000
7B Heat exchanger S2113800
7BB Gasket, vent adapter 12H5501
7C Washer, clamping, hx bracket 12H3023
7D Washer, M5, lock, internal tooth F2023700
7E Screw, M5-0.8 X 14mm, soc Hd F2025300
7G Gasket, blower fan S2105400
7H Screw, #8-18 x 1/2, phil pan hd F2027000
7I Vent, air, auto, 1/4" bspp P2074500
7J Pipe, air vent 12H4010
7K Sensor, temperature, water, 1/4" npt RE2320600
7L Rivet, pop, 3/16 diameter F2015900
7M Terminal, 1/4" push-on, male, red E0005501
7N Heat exchanger S2113800
7O Blower, combustion air RA2107500
7P Washer, sealing, .410 OD F2027700
7Q Plate, venturi 12H5002
7R Screw, m5 x 8, soc hd cap F2029300
7S O-ring, 2 1/8 id x 3/32 thick S2116000
7T Adapter, vent, cpvc 12H5500
7U Plug, hex, 1/8" npt 500-168
7V Sensor, temperature, air, 1 /4" bsp, 1.85 l RE2319700
7W Sensor, temperature, water, duplex RE2319900