Install and Operating Manual
Mighty Therm2
Page 3
SECTION 1.
General Information
USING THIS MANUAL – Because Mighty
Therm2 Boilers and Water Heaters are identical
appliances, with the exception of materials of
manufacture, labels and ultimate use application,
this manual provides information for the proper
installation, operation and maintenance of all
products. Where differences exist between the
application of the appliances and their operation, the
sections pertinent to only one appliance or the other
will be so identied.
In the Commonwealth of Massachusetts, this app-
liance must be installed by a licensed plumber or gas tter.
WARNING
must
detailed in this manual, or the Laars Heating Systems
having authority, and, in the United States, to the
conform to the Standard for Controls and Safety
1.1 Introduction
This manual provides information necessary for the
installation, operation, and maintenance of Laars Heating
Systems Mighty Therm2 copper tube appliances. Read it
carefully before installation.
All application and installation procedures should
be reviewed completely before proceeding with the
installation. Consult the Laars Heating Systems factory,
or local factory representative, with any issues or
questions regarding this equipment. Experience has
shown that most operating issues are caused by improper
installation.
The Mighty Therm2 appliance is protected against
over pressurization. A pressure relief valve is tted to
all appliances. It is installed on the outlet header, at the
water outlet of the appliance.
IMPORTANT: The inlet gas pressure to the appliance
All installations must be made in accordance with:
1). In the U.S., the " National Fuel Gas Code"ANSI
Z223.1/NFPA54, Latest Edition and all applicable local
codes as required by the Authorities Having Jurisdiction
(AHJ), or
2). In Canada, the "Natural Gas and Propane
Installation Code", CSA B149.1, latest edition and
all applicable local codes as required by the AHJ.
All electrical wiring is to be done in accordance with:
1). In the U.S., the "National Electrical Code"
(NEC), ANSI/NFPA 70, latest Edition and all applicable
local codes as required by the AHJ, or
2). In Canada, the “Canadian Electrical Code - Part
1”, CSA STD. C22.1 and all applicable local codes as
required by the AHJ.
This appliance must be electrically grounded in
accordance with the applicable codes and standards
referenced above.
M T 2
0 5 0 0
0 7 5 0
1 0 0 0
1 2 5 0
1 5 0 0
1 7 5 0
2 0 0 0
1
OPTIONS
X
J
FM
H
V
N
P
PUMP
OPTIONS
X
H
N
S
C
B
D
A
C
K
B -
C -
N -
P -
HLW STAMP
2 -
5 -