Owner's manual

DeviceControl Operation Manual 33
The DIP-switches tab (Figure 6.14) displays DIP-switch positions of the configured device and the matched
physical device, if any. Physical device status is shown only when power is on. Positions of DIP-switches may
be changed on a configured “virtual” device by clicking on them. Any resulting mismatch is indicated by a red
fault or yellow warning LED. The Power and sensitivity calculator shows output power and input sensitivity for
the configured DIP-switch settings. Refer to specific amplifier Operation Manuals for more information.
Figure 6.14
Position of physical amplifier DIP-switches cannot be changed by DeviceControl.
reference section 6