Manualshelf

Operation Manual

ManualsBrandsLab Gruppen ManualsPower Amplifiers20,000 Watt Amplifier with 4 Flexible Output Channels, Lake Digital Signal Processing and Digital Audio Networking for Installation Applications
31323334353637383940
13. System configuration tutorial
36
D SERIES Lake Operation Manual rev 3.0.4
13. System configuration tutorial
D SERIES Lake Operation Manual rev 3.0.3
35
(which should be default on modern operating systems), it will reside in the same subnet as the devices and
address in the 172.31.0.0 – 172.31.255.255.
13.2. Software installation and firmware update
13.2.1. Lake Controller software suite
1. The Lake controller software suite includes the Lake controller and accompanying utilities: Lake LoadLibrary,
Dante discovery services and documentation. Download the Lake Controller installation from
www.labgruppen.com.
2. Execute the installer and follow the on–screen instructions. This is a typical software installation where the
default settings are acceptable for the vast majority of users.
13.2.2. CAFÉ software
1. The CAFÉ software is available as a separate installer on www.labgruppen.com.
2. Execute the installer and follow the on–screen instructions. This is a typical software installation where the
default settings are acceptable for the vast majority of users.
13.2.3. Firmware update
1. Make sure all frames are powered on and connected through a wired network.
2.
3. Select the appropriate product range.
4. If more than one network adapter is enabled, a prompt will appear requiring selection of the adapter connected
to the frames.
5. If prompted, allow the application access through the Firewall.
6.
7.
Frames already up to date will not be selected.
8. Read warning message and tap OK.
9. Wait for all updates to be completed. A wait indication will display on the unit(s) during updating.
10.
a manual power cycle is required. (Note: A manual power cycle requires the mains plug to be completely
11. If internal updates are needed, these will be performed by the frame after the power cycle. A wait indication is
displayed.
12. Tap Exit to close the update utility.
The latest firmware for the product is included in the Lake controller installation. It is likely that firmware installed on
the new product is older and requires updating. The firmware bundle includes all internal components
(so no separate update for Dante etc. are needed).